Polymer-aided flocculation is defined in this study as the coagulation and flocculation process which is accomplished by using alum in conjunction with a small dosage of polymer. Polymer is commonly used to improve flocculation performance; however, few in-depth studies of mixing requirements when using polymer as an aid have been reported. Presented is an evaluation of the effect of mixing on the kinetics of polymer-aided flocculation. The study found that the optimum f-values occurred at 70 to 100 s−1, such that ftb-values (Camp Number) were in the range of 113,000 to 144,000. The limited improvement in kinetics achieved by increasing the f-value beyond 100 s−1 will probably not justify the higher energy consumption. Moreover, experimentation has shown that the maximum f-value recommended for the design is f=200 s−1 (ftb=252,000), and the critical mixing rate occurred at f=400 s−1 (ftb=432,000), beyond which significant floc break-up will occur. The optimum f-value determined from the study suggests that the currently designed flocculators using alum alone can be used when polymer is used as a coagulant aid. Thus, the use of polymer as a coagulant aid can improve the coagulation and flocculation efficiency in existing systems.

You do not currently have access to this content.