Physical properties of menstrual hygiene waste as feedstock for onsite disposal technologies

Onsite incinerators offer a promising solution to the challenges of menstrual waste disposal, particularly in institutional settings. However, thermochemical processes are well known to depend on the nature of the feedstocks and their moisture content (MC). An analysis is presented of the physical properties of menstrual waste as potential feedstock for onsite incinerators. Waste was generated in three institutional settings – from women of wide age range and from people with different socioeconomic backgrounds such as workers and students. Over 10 separate collections, 613 discarded menstrual pads were obtained with over 93% of the waste representing commercially disposable pads and less than 7% of the waste appearing to be homemade cloth pads. A surprising finding of this study was that a significant fraction of the commercially disposed pads (23–37%) had a large wet weight (over 20 g) which was associated with MC exceeding 50 wt%. This high MC was attributed to the practice of washing the pads prior to disposal, and it was much higher than what is standard for thermal processing. These data suggest that testing protocols for menstrual waste incinerator technology performance should include an evaluation of the effects of higher MC, unfolded pads, and occasional cloth pads.

Disposal of used sanitary pads is a critical element of the MHH value chain. Cloth pads are cheaper and environmentally less polluting, but cleaning is challenging since it requires access to water, privacy and drying in the sun for its disinfecting effect, as opposed to a hidden drying area utilized for a sense of shame (van Eijk et al. ). Disposable pads offer convenience of use and are considered as aspirational products for women and girls; however, they present a solid waste challenge. A woman will have an average of 459 periods over her lifetime and dispose of 125-150 kg of sanitary waste (Bharadwaj & Patkar ).
The lack of disposal solutions leads to negative health outcomes, e.g. infrequent pad changes during school (Singh & Bhardwaj ) as well as environmental issues.
Where solid waste management is not available, disposal In addition to the lack of sanitation infrastructure, menstruation is associated with stigma and taboos such as the perception of impure or shameful processes leading to restrictions of women's activities during menstruation and secrecy around menstrual fluid management (Sommer et al. ; Garg & Anand ). Importantly, cultural beliefs and taboos, in addition to convenience and information, contribute to the selection of disposal method (e.g. bury or burn) and to practices such as washing pads before disposal (Ali & Rizvi ; Sommer et al.

).
Onsite incineration is an option for managing the disposal of menstrual waste to achieve both pathogen and volume reduction, thus alleviating the environmental problems associated with improper disposal. Small-scale incinerators placed within a toilet facility may provide an effective and discrete way of disposing menstrual absorbents, align with decentralized waste treatment practices, and are well suited for institutional settings such as schools and worksites (Elledge et al. ).
Concerns in regard to the adoption of incineration are related to negative health and environmental impacts associated with the release of pollutants and toxic emissions as well as incomplete waste processing (Sommer et al. ); in the past decade, poor design and insufficient operation and maintenance have resulted in negative experiences for people (Tilley et al. ).
The Government of India has promoted the adoption of incineration for menstrual waste as part of its Swatch Bharat (Clean India) mission (2018). In India, menstrual waste volume is significantly high, with an estimated 121 million women disposing of 113,000 tons of menstrual hygiene waste (12.3 billion pads) annually (Path ). A number of programs implemented to increase access to sanitary pads have been successful in achieving widespread adoption recently, with an estimated 98% urban women using them (Dixit et al. ) and 64% of women in lowincome areas gaining access to such pads (Garikipati & Boudot ). It is estimated that over 50 suppliers on the In order to enable the evaluation of menstrual pad incinerators based on realistic feedstock characteristics, this paper characterizes the physical properties of menstrual waste in the context of feedstocks for incineration. We collected and characterized menstrual waste from women's bathrooms from three institutional sites in India, and this paper reports our findings on the nature of the waste and its physical parameters: wet weight and MC.

Site characteristics and study population
Menstrual waste was collected from three sites in the city of Coimbatore, India, between September 2019 and March 2020. All sites were communal women's toilet facilities: a private textile factory and two student residence halls in an educational institute, Hostel 1 and Hostel 2.
The collection of pads was carried out by the caretakers (custodian or janitor) of each facility. The caretakers received an orientation about the purpose of the project prior to the beginning of the study and wore personal protective equipment (masks and gloves).
Site 1: The private textile factory site is a shared toilet for live-in and day workers. According to the warden, the number of users ranges between 20 and 50 women between 18 and 50 years of age. The facility has five toilet stalls, with a dedicated lidded bin for menstrual waste disposal. After an accumulation period of 2-3 weeks, the five bins were collected by the caretaker by placing the waste in one larger disposal bag and delivered to the investigators for analysis. Five separate collections were used for this study, yielding a total of 304 pads. Four separate collections were carried out at this site for one or more floors for a total of 47 bags.
Site 3: Hostel 2 is a multistorey building housing approximately 350 female students, estimated to be between 23 and 30 years of age. Each floor contains a toilet facility with 10 individual toilet stalls. One waste bin is shared between two toilet stalls. The janitors empty the individual waste bins daily into one large disposal bag per floor, similar to hostel 1. Black garbage liners for the bins were provided to the caretakers the day before collection. After 1 day, liners containing at least one pad were delivered to the investigators. One collection was carried out at this site for a total of 24 bags.

Menstrual waste physical analysis
Analysis began the same day menstrual waste was received from the caretakers. Metal tongs were used to sort the waste into individual pads. For each pad, its type was recorded as either commercially disposable cellulose or homemade cloth (Figure 1(c)). Commercial pads were further analyzed for disposal shape and assigned one of the following categories: unfolded, rolled up/crumbled, or stuck together. Pads that were stuck together due to exposed adhesive liners were recorded as such and not analyzed further. Additional information collected from commercial pads included the presence of wings and additional coatings, as determined by a different color of the substrate material.
Cloth pads were homemade and nonuniform in size; therefore, we recorded the length, width, and layers of cloth of the pad.
In a fume hood, an analytical balance was used to record the wet weight for all individual pads received. A subset of approximately 15-18 pads from each collection was further evaluated for MC analysis. Pads were assigned to three weight categories based on wet weight: low (5-20 g), medium (21-40 g), and heavy (>41 g). The pads for MC measurements were randomly selected in quantities proportional to their number in each of the three weight categories.
MC was calculated using the conventional formula % MC ¼ (W wet À W dry /W wet )*100, where W wet is the wet weight and W dry is the dry weight. Pads were placed inside a vented hot air oven whose temperature did not exceed 100 C (typically 55 À 70 C) (Figure 1(d)). The drying temperature is lower than the standard value of 105 C because of the limited temperature control capability of the oven.
By drying at 55-70 C, we ensured that no temperature swings exceeded 105 C, which would cause mass loss to volatilization, and thus, we obtained an accurate dry weight value at the cost of longer drying times. The weight of the pads was recorded over multiple days until it did not change more than 4% from prior measurement, thereby providing the dry weight value. After the completion of analytical characterization, all specimens were discarded as biohazardous waste.

PSG IMSR's Institute Human Ethics Committee (IHEC)
reviewed and approved the study as exempted (2018/ Appr/Exe/017). Duke University IRB determined the study to be non-human subject research.

RESULTS AND DISCUSSION
A total of 613 discarded menstrual pads were collected over multiple collections from three institutional sites, a factory and two residence halls from an institution of higher education (Hostels 1 and 2). Two types of menstrual waste were observed: commercially disposable cellulose pads and homemade cloth pads. The overwhelming majority (!93%) of the pads collected from the three sites were commercially disposable pads, and of these, a large majority had wings or some type of cellulose coating as detected by different colored pad material. Homemade cloth pads were found in waste in two of the three sites, namely, the factory and Hostel 1. Results over multiple collections at the same sites were consistent over time. Table 1 summarizes the

Properties of commercial pads
There was a difference in the manner of disposal across sites, with the pads at the factory site being largely disposed of as unfolded, while at the hostels, we observed a mix of unfolded and rolled up, often wrapped by a piece of newspaper. We note that India being a country with a washing culture, bathrooms do not feature toilet paper, which is commonly used as a wrapper prior to disposal in other geographies. Unfolded pads are likely to stick to each other and form clumps that may be problematic for incineration, cause them to stick to surfaces, or be improperly positioned inside the incinerator.
The number of clustered pads was higher at the factory site than at the hostels due, in part, to both the manner of collection and the adoption of liner bags for the menstrual waste bins at the hostels.
The wet weight of the pads had a similar median value consistent across sites (median wet weight between 13.9 and 15.8 g); however, the range was very broad, from 5.7 to 89 g. The dry weight of the pads had median values 7.6-8.9 g and ranged between 4.7 and 14.1 g, consistent with typical ranges for different commercial pad sizes.
Commercial pads are designed to absorb typically 5 ml and, in some models, up to 10 ml of liquid (Fraser et al. ). Given that blood density is slightly more than water (1.06 g/ml), we estimate that blood adds 5-10 g to the dry weight of pads. Using the largest dry weight measured, for pad, of 14 g, we estimate 14 g (pad) þ5 g (blood) ∼ 20 g as the maximum weight of used pads (dashed line in Figure 2), being aware that in some cases we may observe 14 þ 10 ¼ 24 g. Figure 2 shows the wet weight distribution of the pads, indicating that approximately half of the collected waste was below 15 g, with the majority below the expected maximum weight of 20 g. However, a long distribution tail of wet weights higher than 20 g was recorded for all three sites, particularly at the factory site, where as many as 37% of the pads were heavier than 20 g. Weights are plotted against measured MC in Figure 3. The data show that, consistently across the three sites, heavier wet pads feature very high MCs reaching 80-90%. The dotted line at 50% MC corresponds to an 8 g dry pad receiving 8 ml of blood.
This is expected to be an upper limit for MC for two reasons: (1) the typical volume of blood for pad rarely exceeds 5 ml and (2) in this study, drying of the pad can occur during  the time between disposal and collection (time lag ¼ 1 day for hostels, 1-2 weeks for the factory site). Yet, the measured moisture values are too high to be consistent with moisture from menstrual blood alone. While we did not conduct chemical analysis on the liquid, we note that since India has a washing culture, a tap with water per personal wash is available in each of the toilets included in this study.
Thus, we infer that wet heavy pads derive from the practice of washing them prior to disposal (Ali & Rizvi ; Sommer et al. ). This practice is associated with the concept that menstrual blood is impure and the belief that others should not see it, and also possibly with a lack of awareness on proper disposal practices (Garg & Anand ).
While MC was not measured for all pads (wet weight was measured), all pads in Figure 3 whose wet weight exceeded 20 g had a MC exceeding 50% (dotted line).
Thereby, a significant portion of disposed pads (23, 28 and 37%) with wet weight above 20 g were estimated to have a MC ranging from 50 to 90%. Such high moisture levels could be problematic for thermal processing because they significantly exceed the optimal 15-25% feedstock moisture (Dong et al. ; Eke et al. ).

Properties of cloth pads
Out of the 613 pads collected in this study, 33 were homemade cloth pads. We note that since the cloth pads are reusable, the low fraction of disposed cloth pads does not represent an indication of how prevalent their use is. It is, however, an indication that the menstrual pad incinerator should be evaluated for its ability to process feedstock that contains a percentage of cloth material that has been reused multiple times. as 38 cm was folded in layers to serve as a pad (for reference, the length and width of a typical commercial pad product is 25 cm length × 7.2 cm width). The MC of the homemade cloth was, however, narrower than that observed for the commercial pads and ranged between 16 and 40%. Also, the MC was not associated with wet weight, with some of the heavy pads consisting of a larger quantity of material.
A possible explanation for the difference in MC between cloth and commercial pads is the fact that commercial cellulose pads are designed to absorb liquid and, therefore, when washed, retain a large amount of liquid, while cloth pads can dry more easily after disposal.

Comparison with prior studies
Prior studies of menstrual waste are based on surveys, and only a few of them address specific questions on disposal practices that are relevant to our physical assessment results.
A key finding of this study is that a significant fraction of the commercial pads (23-37%) was associated with a high MC consistent with washing prior to disposal.

CONCLUSIONS
We investigated the physical properties of menstrual waste as feedstock for incinerators that represent an attractive solution to the challenges of menstrual waste disposal, particularly in institutional settings.
Menstrual waste was generated by women of different ages (18-50 years) and different education/income (workers vs. college students), yet consistent outcomes were observed across the two groups. The use of commercial cellulose pads was prevalent at all sites (>93%), in agreement with recent reports (Dixit et al. ; Garikipati & Boudot ). In two out of three sites, 6-7% of the waste consisted of homemade cloth pads, suggesting that a menstrual pad incinerator technology will encounter multiple types of feedstock. The commercial pads were disposed both unfolded or folded, indicating that the incinerator configuration should be robust with respect pad insertion and positioning inside the unit; folded pads were not wrapped in manufacturer-provided wrappers, despite country regulations and standard use instructions.
A major finding of this study was that a significant fraction of the commercial disposed pads (23-37%) had a large wet weight (over 20 g), which was associated with MCs exceeding 50%. This MC is much higher than ideal for thermal processing (<25%) and can be quite problematic for typical incinerators, leading to incomplete combustion and increased hazardous air emissions. We infer that the MC is due to the practice of washing pads before disposal, a practice that has been reported in washing cultures. While this study on menstrual waste in India is limited to three sites, hundreds of pads were collected in repeated collections over periods of months, and the results were consistent across collections. These findings suggest that further research is needed to fill the knowledge gap on practices in menstrual disposal and that testing protocols of disposal technologies should include an evaluation of the effects of high MC, unfolded pads, and occasional cloth pads on waste processing performance.