The adsorption and desorption behaviour of a cationic polyelectrolyte contacted with wood pulp fibers was determined by total nitrogen analysis using a pyrolysis/chemiluminescence detection system. Dialysed polymer generated an adsorption isotherm of higher affinity than did non-dialysed polymer. Capacity adsorption was maximized at pH 7, but decreased in the presence of alum depending on the dosage. Desorption of non-dialysed polymer was caused by changes in pH above or below 7.0 as well as by addition of alum. However for the alum doses typically encountered in paper manufacturing, significant desorption is unlikely. Nevertheless, the contaminants in non-dialysed polymers do hinder adsorption, and effluents from those processes using both alum and polymer may contain quantities of unadsorbed or desorbed polyelectrolytes which could be damaging to receiving water bodies.
Desorption of Cationic Polyacrylamide from Bleached Kraft Pulp Fibers
Clifton F. Warren, R. Gehr; Desorption of Cationic Polyacrylamide from Bleached Kraft Pulp Fibers. Water Sci Technol 1 May 1987; 19 (5-6): 939–951. doi: https://doi.org/10.2166/wst.1987.0272
Download citation file:
Impact Factor 1.915
CiteScore 3.3 • Q2
First Decision in 30 days