The treated effluent of the Southpest Wastewater Treatment Plant is discharged into a small, low-flow branch of the Danube susceptible to eutrophication. The first, high-load activated sludge system with a hydraulic retention time of 2.5 hrs in the aerated basins, was installed here in 1966. The paper presents the evolution of the technology by illustrating the effects of the different changes carried out since 1991.

Reconfiguration of the existing activated sludge basins connected originally in parallel into an arrangement of tanks in series increased the settleability of the sludge as well as the efficiency of COD removal significantly. Introduction of an anaerobic zone preceding the aerated basins facilitated biological excess phosphorus removal with a consequent release in the thickener and digester. Introducing lime addition into the recycled sludge processing wastes significantly improved the performance of the system. However, since there had been no provision built for eliminating the nitrate content of the recycled sludge, efficiency of phosphorus removal proved to be dependent on the eventually occurring nitrification.

In order to achieve both an effective nitrogen and phosphorus removal the current technology established in 1999 applies a nitrification and a denitrification filter following the activated sludge unit and uses precipitation for phosphorus removal.

This content is only available as a PDF.
You do not currently have access to this content.