In 1999 the Activated Sludge Model no. 3 (ASM 3) by the IWA task Group on Mathematical Modeling for Design and Operation of Biological Wastewater Treatment was presented. The model is used for simulation of nitrogen removal. On the basis of a new calibration of the ASM 3 with the easy degradable COD measured by respiration simulation runs of this paper have been done. In 2000 a biological phosphorus removal module by the EAWAG was added to the calibrated version of ASM 3 and is now serving the current requirements for modelling the enhanced biological P-removal. Only little experiences with different load situations of large-scale wastewater treatment plants were made with both new models so far. This article reports the experiences with the simulation and calibration of the biological parameters using ASM 3 and the EAWAG BioP Module. Three different large-scale wastewater treatment plants in Germany with different treatment systems will be discussed (Koblenz: pre-denitrification; Hildesheim: simultaneous denitrification with EBPR; Duderstadt: intermediate denitrification with EBPR). Informations regarding the choice of kinetic and stoichiometric parameters will be given.
Modelling of full-scale wastewater treatment plants with different treatment processes using the Activated Sludge Model no. 3
M. Wichern, F. Obenaus, P. Wulf, K.-H. Rosenwinkel; Modelling of full-scale wastewater treatment plants with different treatment processes using the Activated Sludge Model no. 3. Water Sci Technol 1 July 2001; 44 (1): 49–56. doi: https://doi.org/10.2166/wst.2001.0012
Download citation file: