Effects of addition sequence and rapid mixing conditions on use of dual coagulants

The performance of dual coagulants in clay suspension was investigated in this study using aluminium chloride and the cationic polymer as coagulants. According to the study results, the performance of dual coagulants was affected by dosage of aluminium chloride. Beneficial effect by use of dual coagulants were only noted when aluminium chloride was underdosed. The addition sequence of coagulants was important for the performance of dual coagulants. Simultaneous addition resulted in the best performance, while addition of the polymer first resulted in the worst performance. Addition of aluminium chloride first resulted in the similar performance as single use of aluminium chloride. Although sulphate ion improved the floc characteristics, similar results were obtained. The effectiveness of rapid mixing depended on dosage of aluminium chloride. Extending rapid mixing (6 min) was beneficial when aluminium chloride was underdosed so that coagulation occurred at the combination region. However, such benefit was not observed at the optimum condition, which belonged to the sweep coagulation region. Different floc formation caused the difference. Extended rapid mixing would be beneficial when collision between clay particles and Al(III) was necessary. However, such benefit would disappear at the optimum condition because rapid mixing could break up the floc already formed.