Stormwater quality simulation models are useful tools for the design and management of sewer systems. Modelling results are highly sensitive to experimental data used for calibration. This sensitivity is examined for three modelling approaches of various complexities (site mean concentration approach, event mean concentration approach and build-up, washoff and transport modelling approach) applied to a typical case study (design of a dry detention tank), accounting for the variability of calibration data and their effect on simulation results. Calibrated models with different calibration data sets were used to simulate 3 years of rainfall with different retention tank specific volumes. Annual pollutant load interception efficiencies were determined. Simulations results revealed i) that there is no advantage in using the EMC model compared to the SMC model and ii) that the BWT model resulted in higher design ratios than those given by the SMC/hydraulic approach. For both EMC and BWT models, using an increasing number n of events for calibration leads to narrower confidence intervals for the design ratios. It is crucial for design ratios to account for successive storm events in chronological order and to account for the maximum allowable flow to be transferred to the downstream WWTP.
Design of a retention tank: comparison of stormwater quality models with various levels of complexity
M. Mourad, J.-L. Bertrand-Krajewski, G. Chebbo; Design of a retention tank: comparison of stormwater quality models with various levels of complexity. Water Sci Technol 1 September 2006; 54 (6-7): 231–238. doi: https://doi.org/10.2166/wst.2006.582
Download citation file:
Impact Factor 1.915
CiteScore 3.3 • Q2
First Decision in 30 days