Simulation studies for a full-scale anaerobic unit of a wastewater treatment plant (WWTP) were performed using the anaerobic digestion model no. 1 (ADM1). The anaerobic full-scale plant consists of one mesophilic and one thermophilic digester, operated in an anaerobic sequential batch reactor (ASBR) mode, and sludge enrichment reactors (SER) for each digester. The digesters are fed with a mixture of vegetable waste and process wastewater from the food factory. Characteristics such as CODtotal, Ntotal and NH4-N concentrations in the influent and effluent of the digester and SERs were measured and used for input fractionation. Parameters such as level, pH, biogas amount and composition in the digester were measured online and used for calibration. For simulation studies, different temperatures and operation modes with varying chemical oxygen demand (COD) input loads corresponding to feedstocks such as fruits, vegetables and grain were analysed and compared. Higher gas production and digestion efficiency in the thermophilic reactor and in shorter cycles were found and confirmed at full scale. Serial operation mode increased the gas production, but pH inhibition occurred earlier. Feeding only biosolids into digester I and the effluent of digester I together with process water into digester II further improved gas production in serial operation mode.
Comparison of different conditions, substrates and operation modes by dynamic simulation of a full-scale anaerobic SBR plant
S. G. E. Rönner-Holm, A. Żak, N. C. Holm; Comparison of different conditions, substrates and operation modes by dynamic simulation of a full-scale anaerobic SBR plant. Water Sci Technol 1 February 2012; 65 (3): 558–566. doi: https://doi.org/10.2166/wst.2012.887
Download citation file: