Comprehensive modelling of overland flow requires models for both rill and interrill area overland flow. Evaluation of a physically based mathematical model for simulating overland flow generated on rill and interrill areas of hillslope was done using a data set gathered from a laboratory experimental setup. A rainfall simulator has been constructed together with a 6.50 m × 1.36 m erosion flume that can be given adjustable slopes in both longitudinal and lateral directions. The model was calibrated and validated using the experimental results from the setup of the flume having 5% lateral and 10% longitudinal slopes where rainfall intensities of 105 and 45 mm/hr were induced with the use of nozzles. Results show that for the given slope combination, the model was capable of simulating the flow coming from the rill and interrill areas for the two different rainfall intensities. It was found that significantly more of the flow occurred in the form of the rill flow. The model studied here can be used for the better prediction of overland flow and can also be used as a building block for an associated erosion and sediment transport model.
Evaluation of overland flow model for a hillslope using laboratory flume data
A. C. C. Arguelles, M. Jung, G. Pak, H. Aksoy, M. L. Kavvas, J. Yoon; Evaluation of overland flow model for a hillslope using laboratory flume data. Water Sci Technol 1 September 2013; 68 (5): 1188–1194. doi: https://doi.org/10.2166/wst.2013.341
Download citation file:
Impact Factor 1.915
CiteScore 3.3 • Q2
13 days from submission to first decision on average