As dewatered sludge is highly viscous and sticky, the combination of foaming pretreatment and drying process seems to be an alternative method to improve the drying performance of dewatered sludge. In this study, CaO addition followed by mechanical whipping was employed for foaming the dewatered sludge. It was found that the foams were stable and the diameters of bubbles mainly ranged from 0.1 to 0.3 mm. The drying experiments were carried out in a drying oven in the convective mode. The results indicated that foamed sludge at 0.70 g/cm3 had the best drying performance at each level of temperature, which could save 35–45% drying time to reach 20% moisture content compared with the non-foamed sludge. The drying rate of foamed sludge at 0.70 g/cm3 was improved with the increasing of drying temperature. The impact of sample thickness on drying rate was not obvious when the sample thickness increased from 2 to 8 mm. Different mathematical models were used for the simulation of foamed sludge drying curves. The Wang and Singh model represented the drying characteristics better than other models with coefficient of determination values over 0.99.
The thin-layer drying characteristics of sewage sludge by the appropriate foaming pretreatment
Hui-Ling Wang, Zhao-Hui Yang, Jing Huang, Li-Ke Wang, Cheng-Liu Gou, Jing-Wu Yan, Jian Yang; The thin-layer drying characteristics of sewage sludge by the appropriate foaming pretreatment. Water Sci Technol 1 May 2014; 69 (9): 1859–1866. doi: https://doi.org/10.2166/wst.2014.093
Download citation file: