Pulp and paper mill effluents represent a challenge when treatment technologies are considered, not only to reduce organic matter, but also to reduce the toxicological effects. Although anaerobic treatment has shown promising results, as well as advantages when compared with an aerobic system, this process alone is not sufficient to reduce recalcitrant compounds. Thus, an advanced oxidation process was applied. This experiment was performed to determine the effect of ozone and ozone/UV treating a horizontal anaerobic immobilized biomass reactor effluent from a kraft cellulose pulp mill for 306 days with an organic volumetric load of 2.33 kgCOD/m3/day. The removal of organic compounds was measured by the following parameters: adsorbable organically bound halogens (AOX), total phenols, chemical oxygen demand (COD), dissolved organic carbon and absorbance values in the UV-visible spectral region. Moreover, ecotoxicity and genotoxicity tests were conducted before and after treatment with ozone and ozone/UV. At an applied ozone dosage of 0.76 mgO3/mgCOD and an applied UV dosage of 3.427 Wh/m3, the organochlorine compounds measured as AOX reached removal efficiencies of 40%. Although the combination of ozone/UV showed better results in colour (79%) and total phenols (32%) compared with only ozone, the chronic toxicity and the genotoxicity that had already been removed in the anaerobic process were slightly increased.
Skip Nav Destination
Research Article| December 26 2014
Post-treatment of anaerobic effluent by ozone and ozone/UV of a kraft cellulose pulp mill
T. R. Chaparro;
T. R. Chaparro, E. C. Pires; Post-treatment of anaerobic effluent by ozone and ozone/UV of a kraft cellulose pulp mill. Water Sci Technol 1 February 2015; 71 (3): 382–389. doi: https://doi.org/10.2166/wst.2014.527
Download citation file: