This paper presents the results of the study of sludge aggregates produced during electrocoagulation of model wastewater of a composition corresponding to the effluents from the cellulose and paper industry. Wastewater was electrocoagulated statically using aluminium electrodes with a current density of 31.25 A m−2 and 62.50 A m−2. In subsequent stages of the treatment, sludge flocs were collected, their size was studied and their floc settling velocity (30–520 μm s−1) and fractal dimension (D) were determined. The values of D ranged from 1.53 to 1.95 and were directly proportional to the degree of wastewater treatment. Higher values of D were determined for sludge with lower water content (after 24 hours’ settling). Fractal dimension can therefore be used as an additional parameter of wastewater treatment control.
Skip Nav Destination
Research Article| September 15 2015
Analysis of sludge aggregates produced during electrocoagulation of model wastewater
B. Załęska-Chróst, R. Wardzyńska; Analysis of sludge aggregates produced during electrocoagulation of model wastewater. Water Sci Technol 8 January 2016; 73 (1): 161–166. doi: https://doi.org/10.2166/wst.2015.476
Download citation file: