The height of vertical sand filters are limited due to their structural cost. A horizontal sand filter may offer a better alternative; however, flow channels to the least resistance zone generated at the top of the filter as the sand gets wet and settles. A horizontal sand filter, internally baffled with spiral protrusion, is numerically modelled to study the effect of these spirals in reducing the channelling and enhancing the filter's effectiveness. Three different spiral pitches, 1.0, 0.75, and 0.5 m have been numerically modelled using Ansys FLUENT software. The parameters investigated were the power needed to run a flow rate through the horizontal filter and the residence time. The results show that as the spiral pitch decreases, the channelling reduces while the power increases. The power needed to pump a given flow rate of water in a 10 m long horizontal filter in all three cases investigated was less than the power needed to pump the same flow rate to the top of a 10 m long vertically standing sand filter. Results also showed that the time required for the flow to traverse through the sand filter increases in a nonlinear fashion as the pitch size decreases; however, the effectiveness of the filter increases.

This content is only available as a PDF.